Know The Steps To Clean A Water Pipe Bong

If you’re using res caps for sealing off the holes in a Water Pipe Bong, you just need to appropriate measurements of each hole. Use the caps securely for covering the holes at a time. Make sure you double check them after securing them in one place. You cannot find anything worse than flipping your pipe upside down, exposing it to resin buildup. If you do not have res caps, fret not. You can accomplish the same results with a plastic bag and rubber bands. You just need to cover each hole with a solid and strong plastic bag, which can retain the water without undergoing breakage.

Sitting and shaking

After placing the plastic bag, tightly wrap a quality rubber band around the hole and secure it. The next step in cleaning a Water Pipe Bong is to let the material sit. You need to shake it, as well, and repeat the process for three to five times. After securing and triple checking the res caps, shake your bong and let the alcohol and salt mix with one another. You also need to ensure that you agitate the resin as it will help to remove it easily. After that, you need to let it rest for 5-10 minutes before repeating the process.

The repetitions

After the first take, shake the Water Pipe Bong for 30 seconds. Turn it upside down and on its side. Shake it aggressively without breaking any components, internal parts, or dropping the bong. This will disturb and agitate the particles (resin) inside, helping you to clean the piece quickly. Again, repeat the step at least 3-5 times. The soaking process won’t exceed an hour. Sometimes, with the alcohol solution becoming murkier and obscure with resin, you may find it impossible to tell whether the pipe is clean or not. You may need to empty the concerned solution.

The assessment and more repetitions

If your Water Pipe Bong is an old one and you haven’t cleaned it in a while, you may need to refill the piece with alcohol and salt once again. So, get back to square one, throw the res caps on, and complete all the steps again. It’s a tedious rehash, but important for the well-being of your pipe. On most occasions, you can clean your water bong perfectly in just two steps. However, you will also come across people who have to try the process 3-5 times for cleaning their old water pipes to their standards.

Rinsing and drying

Either way, you need to have enough time to clean all the parts of the pipe. One of the most pivotal and neglected steps of the cleaning process is ensuring that you correctly rinse and dry the bong after cleaning it. Alcohol and salt can be hazardous if you inhale their fumes. To prevent such health concerns or risky exposure, you need to wash the pipe completely in room temperature. Extreme temperatures, be it hot or cold, will lead to breaking. For more information visit here: Tank Glass